Mike Outmesguine

Those are exactly the kinds of things you can do with the backpack below. Its secret ingredient: the Junxion Box. Plug a cellular-network card into the book-size open-source-based device, and voilà—instant Wi-Fi hotspot, with speeds averaging around 700 kilobits per second. To power the box, I wired it to a 1.2-amp-hour battery and dropped both into the Voltaic Systems backpack, which has a built-in solar charger. Now I can surf for as long as three hours without being tethered to anything but a cell signal. The project isn’t cheap, but prices for the components and service are sure to come down in the next year or so. In the meantime, you can find me in the hills around Southern California. I’ll be the one surrounded by PSP-packing hikers.

See more photos of the backpack .

Parts List
• Junxion Box wireless gateway $700; junxionbox.com
• Verizon Wireless EV-DO PCMCIA card $100; verizonwireless.com
• Voltaic Systems solar-charging backpack $230; voltaicsystems.com

These parts are available at any electronics store:
• 12-volt battery with spade terminals, 1.2 or higher amp-hour $15
• Male DC power plug, size M $5
• 18-gauge wire, black and red $5
• Female insulated quick-disconnect connectors, crimp-type, sized for battery spade terminals $3
• In-line fuse holder $7
• 20-amp fuse 50 cents

Credit: Illustration by Mckibillo.com

Instructions
1) Plug in your EV-DO card and set up the Junxion Box to automatically assign TCP/IP addresses using DHCP, and disable the authentication splash page.

2) To build the power-adapter cable, cut a length of red wire and a length of black. Strip one end of each wire and crimp a spade terminal connector onto each.

Strip the other end of the red wire, and solder it to one end of the fuse holder. Wrap the connection in electrical tape. Take apart the male DC power plug. Solder the end of the black wire to the negative terminal of the plug and the red wire to the positive. Wrap the exposed positive connection in electrical tape, and reassemble the power plug. Install a 20-amp fuse.

3) Connect the Junxion Box cigarette-lighter adapter to the backpack “power out” plug.

4) Connect the battery cable to the “battery” plug on the backpack’s charge controller.

Now we will setup the recordings.

1. Go into the first two components and choose the recording tab. Set each one to record to mp3, you can setup the naming however you want. (Mp3 recording is VERY processor intensive and I find it can bring my mac mini to its knees if I try to record two at once. If you find this, be sure to use a different format like Apple lossless or wav.)



2. Start your skype call.
3. Go into the first two components again when you are ready to record. Hit the record button and make sure the red dot shows up next to each (WARNING: This is critical or your audio won’t record… We did this with one episode).



4. Record your interview, you can keep an eye on sound levels on the effects tab of each component. It is important to make sure you are staying under 0 and you don’t make the clip light go red.



5. When you are finished, hit recording again for the two components. You can also stop hijacking the three components and shutdown AudioHijack Pro.